Firecrest 100mm Holder Kit MKI

Features:

• Revolutionary new top and bottom covers to almost completely eliminate light leakage when shooting long exposure, with interchangeable end caps for use with 100x100 filters or 100x125/150mm graduated filters.

• Built in low-profile gasket.

• Adapters / step rings come with the system as standard for all sizes from 67-82mm, and step rings for smaller lenses can be purchased separately (for lens threads 46mm, 52, 58 & 62mm)

• Integrated top of the range Firecrest 82mm polarizer comes as standard within the system. A unique geared mechanism allows for easy rotation whilst installed. The polarizer can also be removed within its ring/Adapter for use as a screw in

• 2 fixed filter slots which take 100mm filters

• Extremely high quality lightweight aluminum design with extra oxidization to reduce likelihood of scratching

The holder is designed for use with standard lenses and standard wide angle/zoom lenses up to 16mm. For super-wide lenses the LucrOit 165mm system should be used.

 

Lens Compatibility

If you are using the following lenses, it is recommended that you purchase the additional corresponding rotating Adapter ring to ensure there is no vignette.

• Sony 24-105 f4

• Canon 17-40 - requires additional rotating Adapter ring

• Canon 17-55 - requires additional rotating Adapter ring

• Tokina 11-16 - requires additional rotating Adapter ring

• Nikon 16-35 f/4 - requires additional rotating Adapter ring

• Tamron 24-70 G2 - some vignette at 24mm, no upgraded ring available

• Nikon 24-270mm VR - some vignette at 24mm, no upgraded ring available

Each Firecrest 100mm Holder Kit contains:

• Firecrest 100mm rectangular filter holder with polarizer control wheel

• Rotating 82mm Adapter Ring lens mount

• 82mm Firecrest Ultra-slim (non-rotating) Circular Polarizer

• Two part anti-reflective soft-touch outer case

• 1 x Set of Solid End caps

• 1 x Set Vented End caps for use with graduated filters

• 67-82mm Step-up ring

• 72-82mm Step-up ring

• 77-82mm Step-up ring

• Luxury pouch

• Allen key

Troubleshooting & Maintenance

In some instances the screw holding the retaining clip in place can work loose in transit, either during shipment or after frequent or prolonged traveling. This may result in a loose fit when the holder is clipped onto the Adapter ring. To resolve this issue, simply use the allen/hex key provided with the kit to re-tighten the screw. This should be tightened enough to allow free movement of the clip, while ensuring a secure fit. To test this, fit the Adapter ring in to the holder and push/pull it, when secure the Adapter ring will not move any more than 0.5 - 1mm. Any movement more than that means the screw needs tightening.